STEP 1: Reset your Pocket Spectrum.

Before you can pair the Pocket Spectrum with your iPAQ6315, the Pocket Spectrum should first be reset. To do this...

1. Turn off the Pocket Spectrum (if it is already on).
2. Press and Hold the ON button for at least 3 seconds.
3. When the paper starts advancing, release the ON button.
    A diagnostic sheet will be printed.
4. After the print out completes, the printer' bluetooth memory is cleared and ready for pairing to your PDA.
   

NOTICE:  If you are REINSTALLING a Pocket Spectrum, this will erase the existing pairing.  You MUST delete the connection in your PDA before performing the next step.

 

3. Tap the Device tab
4. Turn ON Pocket Spectrum (if it is not already on) and tap New Partnership...
    Wait until the Mobile Pocket Spectrum appears in the List (ie: MSP430026)

5. Select the Pocket Spectrum (ie: MSP430026) and Tap Next
6. Next enter Passkey 1000
7. Tap Next
8. Select Serial Port from the list of services
    You can also change the display name (in the example here it is renamed to Spectrum).
9. Tap Finish.



Your Pocket Spectrum is now parried with your device and called Spectrum.
Next you need to assign the Com Port.

STEP 3: Set the Bluetooth Com Port on your Handheld Device.

1. From Bluetooth Settings, tap the COM Ports tab
2. Tap New Outgoing Com Port
3. Select the Pocket Spectrum device (ie: now renamed as Spectrum)
4. Tab Next
5. Under Port, select a new Com Port.
    We recommend that you use Port COM7 if available.

6. Tap Finish when done

Your Pocket Spectrum is now setup to use the Bluetooth connection on Com 7.  If it will not allow Com 7, select Com 4
Next you need to setup the Pocket Verifier Software to work on the same Com Port (7 or 4).

NOTE: AT THIS POINT TURN THE CARD READER OFF, WAIT A MINUTE, THEN TURN IT BACK ON.

Step 4: Set the Printer/Reader and Com Port in Pocket Verifier.

1. Open Pocket Verifier
2. Log into your Account
3. Go to the Options screen

4. Change the Printer/Reader to Pocket Spectrum
    Confirm the changes.

5. Tap Settings, then Com Port
6. Change the port number to the one selected above (i.e., Com 7 or 4 as selected above)
7. Tap Ok, then Accept.

Your handheld device is now setup to work with the Pocket Verifier software and Pocket Spectrum!