Pocket Spectrum Bluetooth credit card reader setup for Windows Mobile Pocket PC

Bluetooth Magnetic Credit Card / Driver's License
Reader and Transaction Receipt Printer
Setup for Sprint Harrier / MDA2K

Just follow these simple steps to link the Pocket Spectrum Printer to your Sprint Harrier or iMate MDA2K. Retire the wire! STEP 1: Reset your Pocket Spectrum. Before you can pair the Pocket Spectrum with your iPAQ6315, the Pocket Spectrum should first be reset. To do this... 1. Turn off the Pocket Spectrum (if it is already on). 2. Press and Hold the ON button for at least 3 seconds. 3. When the paper starts advancing, release the ON button. A diagnostic sheet will be printed. 4. After the print out completes, the printer' bluetooth memory is cleared and ready for pairing to your PDA. NOTICE: If you are REINSTALLING a Pocket Spectrum, this will erase the existing pairing. You MUST delete the connection in your PDA before performing the next step.
	Go to Start > Settings, select the "Connections" tab at the bottom, and then tap on the "Bluetooth" icon.
	If Bluetooth is off, turn it on, then tap on "Bluetooth Manager" on the bottom of the screen.
	Turn on your Pocket Spectrum and tap on "New" at the bottom left.
	Scroll down, and select "Explore a Bluetooth Device"
	Tap on the printer icon.
	When asked for a Pass key enter 1000, then tap OK
	Select "Serial Port", then tap on "Next"
	It will tell you that the shortcut has been created, Tap on "Finish"
	Pocket PC will show you the completed connection and serial port. NOTE: AT THIS POINT TURN THE CARD READER OFF, WAIT A MINUTE, THEN TURN IT BACK ON.
	Open Pocket Verifier Software and Log On, then tap on "Options
	Choose Pocket Spectrum in Options Screen
	Select "Com Port"
	Change Com Port to 6 in Settings menu (The default Bluetooth connection for Sprint devices is on Com Port 6 . Your Pocket PC may differ. See the Using Bluetooth section in the manual that came with your Pocket PC for details.) For non-Sprint models: You can determine your COM port by using Start > Settings > Bluetooth > Services > Serial Port > Advanced THE OUTBOUND PORT IS THE ONE YOU WANT. The Inbound COM port has no use here.
	Tap on "Settings", then select "Port Settings"
	Change the COM settings to 38400,N,8,1
Your Harrier is now setup to work with our Pocket Verifier software. If you are on the sales screen when the Pocket Spectrum is off and you would like to read a card, turn on the printer, wait for the single beep and linefeed, then click on the Bluetooth icon at the top right of the screen. The printer will then be initialized to read the card.