Just follow these simple steps to link the Pocket Spectrum Printer to your Cingular 2125 or T-Mobile SDA

Bluetooth Magnetic Credit Card / Driver's License
Reader and Transaction Receipt Printer
Setup for Cingular 2125

Just follow these simple steps to link the Pocket Spectrum Printer to your Cingular 2125 or T-Mobile SDA. Retire the wire!
Setup a Bluetooth Connection with your Phone
	Reset your Pocket Spectrum. Before you can pair the Pocket Spectrum with your PDA, the Pocket Spectrum should first be reset. To do this... 1. Turn off the Pocket Spectrum (if it is already on). 2. Plug in the charger for the Pocket Spectrum. 3. Press and Hold the ON button. 4. When the paper starts advancing, release the ON button. A diagnostic sheet will be printed. 5. After the print out completes, the printer is initialized.
	Turn on your phone Press the top button located at the top left spine of the phone. This opens the Communications Manager.
	Select Settings > Bluetooth Settings…
	Under the Bluetooth heading select On.
	Select Menu > Devices. A list of Bluetooth devices will appear here. Select Menu > New.
	Your phone will look for the Spectrum
	If more than one item appears in the list, select the Pocket Spectrum, which will show up as "MPSxxxxxxx" Select Next
	Enter the passkey: 1000 Press Next
	After a brief pause your phone will connect to the Pocket Spectrum
	Select OK. NOTE: AT THIS POINT TURN THE CARD READER OFF, WAIT A MINUTE, THEN TURN IT BACK ON.
Set up the Serial service and COM Port.
	Once you have established a connection between the Pocket Spectrum and your phone, the Services screen will appear. If it does not, you may have entered an incorrect passkey or the battery on the Pocket Spectrum or phone may not be fully charged. In most cases, re-entering the passkey and/or charging the devices will avoid this problem. Select Serial Port, Then select Done.
	select Menu > New Outgoing Port
	Select the Pocket Spectrum in the list which will show up as "MPSxxxxxxx"
	Next you need to assign a COM Port that both the phone and Pocket Verifier will recognize. In this example COM7 was selected Uncheck Secure Connection. Pocket Verifier uses its own proprietary encryption for transmitting secured credit card data, so it is recommended that you leave this option unchecked Select Done
	This brings you back to the Bluetooth screen. Select Done then Exit
Set Pocket Verifier to your new COM Port.
	Start Pocket Verifier Logon and go to the Main Index screen Select Settings Select Menu > Select COM Port
	Choose the COM Port that you used above (for example COM7). Select Done When asked to confirm your connection, select Yes. At the next prompt, make sure the Pocket Spectrum is on and continue.
	It is also recommended that you perform a small print test at this stage to make sure your Pocket Spectrum is functioning properly before using it in the field. After a brief pause the Pocket Spectrum will be setup.
Important Note: If this is the first time you are setting up the Pocket Spectrum or have removed the Bluetooth connection by resetting the Pocket Spectrum, we recommend that you perform a print test. In some cases the Pocket Spectrum will feed the paper continuously from the unit. If this happens, remove the battery from the Pocket Spectrum. Replace the battery, turn on the unit and perform another print test. The unit should function as expected.

Your Smartphone is now setup to work with our Pocket Verifier software.